Adjust Profile Number¶
Use this dialog to add a value to profile numbers. All normal profile parameters will receive new numbers accordingly.
Where can I find the dialog?¶
In the toolbox, select the SFI Properties... icon, go to the Road Body tab, and then Adjust Profile Number...
Using the dialog¶
This function can save a lot of manual work if you have changed the centerline. The function updates both the normal profile and broken slopes.
Instructions
- In the From Profile Number field, enter the profile number from which the adjustment should apply. All profile numbers greater than this will be adjusted.
- In the Adjust Profile field, enter the value by which the profiles should be adjusted.
- Click OK to perform the adjustment.
Available Settings¶
| Setting | Description |
|---|---|
| From Profile Number | Specifies the starting profile for the adjustment. All profiles with a higher profile number will be adjusted. |
| Adjust Profile | The value to be added to existing profile numbers. Can be positive or negative. |
Warning
Make sure the adjustment gives correct results, especially for any measured cross-sections.